Telecom

Product: GSM Router

Model No.:GSM 2E1 Channel Bank

GSM 2E1 Channel Bank: It is a newest product for GSM E1 Channel Bank which is efficient to terminate from VOIP to GSM. GSM 2E1 Channel Bank consists 2 set of Channel Bank. Channel Bank connects to E1 PRI of Exchange or VOIP Trunk Gateway with one by one connection. It is the most economic and efficient model for VOIP calling company on originating or terminating from GSM to VOIP to GSM. The function includes

1) Call Detail Record (CDR) for Traffic and accounting management.
2) Remote console through Website for network IP setting, Password validation, call detail record and monitoring the channel status.

Specification :

OVERVIEW:
Each GSM 2E1 system consists 2 sets of Channel Bank
30 voice channels are individually connected with 30 ports of GSM module
A perfect device between digital circuit to GSM
Provide Call Detail Record (CDR) for traffic and accounting management
Can be configured and queried through website by remote console, which includes the network IP setting, password validation, call detail record, and monitoring the channel status
GCB spec in the GSM6:
Providing 6 channels GSM per card
u LED GSM status display
GSM/GPRS:Phase 2+ Compliance
GSM Frequency bands:Tri Band EGSM 900?DCS 1800 and PCS 1900MHZ
Power Consumption:
Speech Mode:230mA(min),260mA(max)
Standby Mode:<6mA(paging rate 2),<3mA(paging rate 9),at GSM 900MHz
SIM card reader :External - connected via interface connector
Antenna:50 Ohm antenna coaxial connector
Temperature range :Normal operation: -20? to +55?
Restricted operation: -25? to -20? and +55? to 70? Storage:-40? to +85?
Power:
Input Voltage:AC90-135V,AC180-264V,50Hz~60Hz?
Input Current:8A for 115VAC,5A for 230VAC
Type:Switching?
Output:+3.3V_28A,+5V_30A,+12V_15A,-5V_0.5A,12V_1A,+5VSB_2A?
Total Power:300W

Telecom

Product: GSM Router

Model No.:SC-355 GSM Interface

GSM Gateway(FCT) model SC-355 with 1 port analog and GSM line. SC-355 GSM gateway can save you much your phone bill and provides you convienent communication on the PSTN line and GSM conversation. The product function includes as follows:

1.Auto - select economic route (LCR Least Cost Routing)
2.Call Transfer From GSM to PSTN ---- For call origination and terination from GSM to VOIP or VOIP to GSM From PSTN to GSM ---- For call transfer to your mobile phone when you are out
3.Polarity Reversal ---- Payphone system
4.Volume modulating system, etc...

Specification

FEATURES:
Conversion of wire & wireless communication
Auto-select economic route
Connecting with local PSTN line, the phone calls will proceed code-transfer dialing process
Set up the Allow-to-Dial Code
Prefix Code Conversion Setting
Polarity reversing function
Definition of DTMF reversing signal
Setting up Specific Call-Transfer
Remote setup password
SPECIFICATION:
Phone impedance: under DC 1kO, AC 600O (exclude wire impedance)
Phone signal receiving level: -3dbm~-24dbm
Phone signal time: 50~100ms
Phone frequency error: ?%
Feed voltage: 48V
Power converter: Input 110V AC or 220V AC, Output 12V DC 1A
GSM SPECIFICATION:
GSM Frequency bands: Dual Band EGSM 900 and GSM 1800(GSM Phase 2+)
GSM class: Small MSIII
Transmit power: Class 4(2W) for EGSM 900 Class 1(1W) for GSM 1800IV
SIM card reader: External ?connected via interface connectorV
Antenna: 50 Ohm antenna coaxial connector

Networking

Product: Ourdoor & Indoor Booster

Model No.: SB-120-05 (0.5W) 802.11b/g Booster & DC Injector

SB-120-05 Booster operating on the 2.4GHz ISM band, is a high performance two-way amplifier using Time Division Duplex (TDD) technology. SB-120-05 can be used at indoor/outdoor to extend the range or increase the throughput efficiently of IEEE802.11b/g wireless radio communication.

The DC injector provides DC power to the outdoor booster or transponder through the RF feed cable without an additional power cord.

It can also be equipped with different types of connector for custom configuration. The standard one is that with female N type at both sides, and we can customize for customers with N-female or SMA type.

SPEC FOR BOOSTER:

Standard: IEEE 802.11b/g
Operating Frequency Range: 2400~2500MHz
Operating Mode: Bi-directional TDD
Transmitter Gain: 10dBm (Typical)
Max. Tx Output Power: 27dBm
Tx Input Power: 2~15dBm
Receiver Gain: 14dBm (Typical)
Max. Rx Input Power: -20dBm
Receiver Noise Figure: 3.8dB
Gain Flatness: ± 1dB over operating range
LED Indicators: Red:RX, Green:Tx, OFF:No Power
Connector: N-type Female (50O) ; SMA connector available for custom design
Lightning Protected: Quarter Wave-length
Power Supply: DC 12V
Power Consumption: 1100mA for Tx / 230mA for Rx
Operating Temperature: -30 °C~60 °C
Dimensions: 5.77?L * 3.46?W * 1.10?H
Weight: 500g

SPEC FOR INJECTOR:

Bias Current / DC Voltage: 1.5A (max.) / 15V (max.)
Insertion Loss: 1dB
Connector: N type female for both sides

Networking

Product: Wireless LAN Products

Model No.: 2.4GHz, 5.8GHz E1 + LAN Spread Spectrum RAdion (2E1, 4E1, 8E1, 16E1)

E1 Point to Point Spread Spectrum Radios is emerging wireless telecommunication technology which combines high frequency microwave technology, digital modulation and demodulation technology, computer control and telecommunication technology. It has been used widely in the aspects of post, electricity, military and professional systems especially for connecting between base stations of mobile communication, variety of enterprises, and academics.

As a approach of rapid connection, it could also been used in emergency and urgent communication widely.

The E1 PTP Spread Spectrum Radios could be operated in the frequency of ISM 2.4GHz, 5.8GHz and could be customized according to customer’s need. The system is a multi-function and multi-purpose total solution of voice which provides data transmission rate from 2 E1 up to 16E1

SPECIFICATION:

System

Capacity: 2E1~16E1 with/without Ethernet

System Frequency: 5725~5875 MHz

Communication Mode: FDD

Emission Type: MSSS (Multiple Sequence Spread Spectrum)

Tx Output Power: < 22dBm

Rx Dynamic Range: -84dBm~-15dBm

Receiver Max Input: < -10dBm

Gain Flatness: Rx ± 1 dB, Tx ± 1 dB

Tx & Rx Isolation : 60dB

Modulation : QPSK

Sensitivity @ BER 10-6

<-87dBm(2E1)

<-84dBm(4E1, 4E1+Ethernet)

<-81dBm(8E1, 8E1+Ethernet8)

<-77.5dBm(16E1, 16E1+Ethernet)

RF Channel

8 channels(2E1)

4 channels(4E1, 4E1+Ethernet)

2 channels(8E1, 8E1+Ethernet)

1 channels(16E1, 16E1+Ethernet)

Channel Spacing: 3.5 ~ 28 MHz

PA Control: 10~22dBm(25°C)

Transmission Distance: 2~40km

Digital Line Interface

E1 Digital Interface: BNC Unbalanced, 75 ohm; RJ-48 Balanced, 120 ohm

Module: 2E1, 4E1, 8E1, 8E1+Ethernet, 16E1, 16E1+Ethernet

Data Interface

RF Interface: N-type

Cable Type & Length

RG-6?100m

RG-8?200m

Management

NMS: Telnet, SNMPv1.0, SNMPv2.0, MIB II

Operation System: Win98, WinMe, Win2000, WinXP

Power / Environment

Power Input: DC -48V / 0.5A (-36~72V)

Operating Temperature: IDU:-5~55°C; ODU:-30~60°C

Humidity : IDU:10%~95%, non-condensing ; ODU:0%~100%

Dimension: ODU: 392(w) × 310(h) × 156(d) mm; 6.84 kg

E1 Modem: 435(w) × 280(d) × 44(h) mm; 4.04 kg

Networking

Product: Wireless LAN Products

Model No.: 802.11a,b,g Dual Band Wireless AP Router


Wireless 802.11a+g Broadband Router is a complete all-in-one networking solution for homes and small/medium enterprises. With its built-in 4 x 10/100Mbps auto-sensing Ethernet switch ports, users can link multiple computers to Internet without any hassle. The built-in wireless function can connect wirelessly with desktop or notebook computers from up to 300 meters away, and simultaneously in wireless 802.11a and 802.11g. The Wireless Router provides multiple levels of security: 64-bit/152-bit key WEP data encryption for high-level security. Moreover, the use of IEEE 802.1X offers an effective framework for authenticating and controlling user traffic to a protected network, as well as dynamically varying encryption keys. Proprietary wireless range extension technology expands wireless range at lower bit rate.

Wireless 802.11a+b Broadband Route is a unique design for local network users to resist hackers from attacking private network and share networking resource. Not only with the NAT as natural firewall, the built-in powerful advanced firewall proceeds SPI (Stateful Packet Inspection), stops LAN users accessing inappropriate web site, as well as setting the Internet accessing time schedule. The content filtering shields children from any inappropriateness program.

PRODUCT HIGHLIGHTS

• Supports all 802.11a, 802.11b and 802.11g networks simultaneously
• 4-port full duplex 10/100 LAN switch
• Wireless link speeds up to 108Mpbs
• MAC and IP address Filtering, plus up to 152-bit WEP Encryption
• DHCP server, NAT technology DMZ and
• Firewall protections
• Atheros XR™ eXtended Range technology

FEATURES & BENEFITS

• Provides High performance universal wireless network connectivity
• Ideal for multi-media data transmission with high speed wireless performance
• Enhanced security management to protect user network
• Supports VPN pass through, including IPSec and PPTP
• Supports routing ability
• Easy and fast installation and setup
  

Tel : +886-2-3234 1496
Fax : +886-2-3234 1393
7Fl., No. 53, Jian Kang Road, Chung Ho City, Taipei Pei Hsien, Taiwan 235
More Products: http://www.suncomm.info,http:// www.suncomm.com.tw
Inquiry: sales@suncomm.com.tw; suncomm@suncomm.com.tw